AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 175
Deleting a component
A (system or user) component can be deleted from the component list (see
page 165). After deletion the component is no longer available for display or
calibration; however, it is still included in the component selection list and
can be added (see page 168) to the component list again later on.
A user component which is no longer required can be finally deleted from the
component selection list (see page 167). The system components cannot be
deleted.
Menu path
MENU → Configure → Component-specific → Active Component
Select component and confirm with ENTER.
Delete component from the component list
1 Press COMP. CONFIG. softkey. The "Configure Component" menu is
displayed with the component list.
2 Select the component to be deleted in the component list.
3 Press softkey COMP. DELETE.
To Next Page
Loading...
