176 AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B
4 Press COMP. DELETE softkey in succession. Enter password (level 3), as
applicable.
The component is deleted permanently from the component list and the
entry "Free" is displayed.
Note: The active component (Type A) and the component used for calibration
(Type K) cannot be deleted.
Delete user component from the component selection list
1 Press COMP. CONFIG. softkey. The "Configure Component" menu is
displayed with the component list.
2 Select any component in the component list.
3 Press CHANGE COMP. softkey, enter password (level 3), as applicable and
then press COMP. LIST softkey. The component selection list is dis-
played.
4 Select the user component to be deleted in the component selection list.
5 Press DELETE COMP. softkey.
6 Press DELETE COMP. in succession.
The user component is permanently deleted from the component selec-
tion list.
To Next Page
Loading...
