AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 177
Changing the unit of a component
The physical unit used for the measured value display of a component, e.g.
ppm or mg/m
3
, can be changed directly in the "Configure Component"
menu.
One of the units defined at the factory can be selected for system compo-
nents. For user components, the choice of units depends on which of the
parameters required for the calculation have been entered during configura-
tion (see page 168) of the component.
Changing a unit of component is possible for the following analyzer mod-
ules:
Analyzer module Unit
Caldos27 ppm, vol.%
Fidas24 ppmC1, ppm, vol.%, mgC/m
3
, gC/m
3
, mg/m
3
, g/m
3
,
%LEL, mgC/l, gC/l, mg/l, g/l
Magnos206 ppm, vol.%
Magnos28 ppm, vol.%
Magnos27 ppm, vol.%
Uras26 ppm, vol.%, mg/m
3
, g/m
3
ZO23 ppm, vol.%
Prerequisites for this are:
• AMC Software version ≥ 3.3.2,
• Measured value display set to ppm at the factory,
• Unit switching activated at the factory.
Menu path
MENU → Configure → Component-specific → Active Component
Select component and confirm with ENTER.
To Next Page
Loading...
