34 AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B
Preparation for installation
Scope of supply and delivery
Standard scope of supply and delivery
• Gas analyzer Model AO2020 (19-inch housing) or Model AO2040
(wall-mount housing)
• Screwed fittings with tubing connectors for the connection of flexible
tubes
• Mains lead, length 5 m, grounded-instrument connector and separate
grounding connector
• Mating plugs (socket housing) for the electrical connection of the
I/O modules (plugged on the I/O modules)
• Screwdriver (required for attaching the electric lines in the mating plugs)
• System bus terminating resistor
• DVD-ROM "Software tools and technical documentation" with software
tools and technical documentation
• Commissioning instruction
• Analyzer Data Sheet
Also in the scope of supply and delivery depending on version
• Connecting cable for the 24 V DC supply to analyzer modules which are
not installed in the central unit
• Connecting cable, T-pieces and terminating resistors for the system bus
(according to order)
• Inserts for the M32 screwed cable glands (only IP54 version)
Fidas24:
• Mains lead, length 5 m, with 4-pin socket connector and separate
grounding connector for the power supply to the heating of the detector
and the heated sample gas connection
• Accessories pack with fittings and O-rings for connection of the sample
gas line
• Exhaust pipe with fitting nut and compression fitting
To Next Page
Loading...
