ABB Conceptpower DPA 500 - Rear View

Modifications reserved
Page 43/94
6.4.2 Rear View
NOTE
PLEASE NOTE THAT THE EMERGENCY SHUTDOWN FUNCTION BY
PRESSING THE BUTTONS ON/OFF 1 + ON/OFF 2 IS DISABLED
Figure 17: Rear view
I/O PORTS
SD Card Slot for the SD card
USB USB connector
DC Input
Power supply connector (only needed if the RJ-45 cable is >75 &
<100m)
UPS Input RJ-45 connector
LED’s
UPS Status
GREEN: when the UPS is on inverter mode
RED: when the inverter is on alarm
Alarm
OFF: if no alarm present
RED: if unread alarm(s) present
BUTTONS
Reset
Press the “Reset” button to reset the remote panel
ON/OFF 1/2
Press “ON/OFF 1” + “ON/OFF 2”: Function disabled
Press “Reset” + “ON/OFF 1” buttons simultaneously, then release
"Reset" and hold the "ON/OFF 1" button for 10 seconds: Touch
screen calibration