ABB Conceptpower DPA 500 - MIMIC Diagram (Module Level)

Modifications reserved
Page 87/94
The Modules selection screen also indicates how many modules are present in the system and their
status according to the table here below.
Active. The UPS module is running in double conversion mode.
Standby. The UPS module is in standby mode (inverter OFF).
Alarm. UPS module with general alarm.
Module switched OFF (load-OFF), but physically present in the frame. (If a module
is not physically present in the frame, no icon appears).
A.3.1.6 Mimic diagram (module level)
Figure 36 here below, shows the Mimic diagram screen of one specific module and is accessible via
the modules selection screen by pressing the icon .
Figure 36: Left: Mimic diagram screen of a UPS module which is “active”
Right: Mimic diagram screen of a UPS module which is “standby”
From this screen is possible to access to the measurements of
Rectifier, Bypass, Battery
and
Inverter
by touching the respective icon.