ABB Cylon FBXi Series - Page 52

FBXi Series | Installation
©ABB 2023 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
52
MAN0149 rev 10
Attaching RMC terminals
Remove the Interconnect (if installed) from the right-hand side of the FLX, FBXi, CBXi or CBX where the RMC
is to be installed.
Slide one RMC connector into the T-slot of the CBX or FLX at the point at which the BUS is to be extended.
Replace the Interconnect