USING A KEYPAD WITH THE FBXi
A CBT-STAT or UCU Room Display keypad can be connected to the FBX at the Sensor port.
Note: If UCU Room Display is used, refer to the
DS0064 UCU10FC/K
for the corresponding Strategy Point Setup.
The Controller Strategy can determine if an override is in place is by connecting to the Override point on the output
module:
The value of the Override point will be '0' when the output is active and ‘1’ when the point has been manually
overridden. This allows the strategy to react to the fact that a point has been overridden.
Note: The corresponding terminal LED will indicate the override condition.
To Next Page
Loading...
