Contents
i DCS 600 Manual for 12 – Pulse Operation
MANUAL FOR 12 – PULSE OPERATION DCS 600 MULTIDRIVE
Chapter 1 - Introduction
How to use this manual ................................................................................................
II F2
1-1
Contents of this manual ................................................................................................
II F2
1-1
Target group.................................................................................................................
II F2
1-2
Associated publications ...............................................................................................
II F2
1-2
Chapter 2 – Twelve–Pulse Technology
Definition of 12 – pulse technology ...............................................................................
II F2
2-1
Advantages of 12 – pulse technology ..........................................................................
II F2
2-1
2.1 Types of 12 – pulse configurations .........................................................................
II F2
2-1
12 – pulse parallel configuration.............................................................................
II F2
2-1
12 – pulse serial configuration................................................................................
II F2
2-2
Sequential configuration .........................................................................................
II F2
2-2
12 – pulse configuration with master / follower link used for tandem motors ..........
II F2
2-4
2.2 T-reactor for 12 – pulse parallel configurations .......................................................
II F2
2-5
2.3 Line/power transformers used in 12 – pulse configurations ....................................
II F2
2-6
2.4 Earth fault (insulation) monitoring ...........................................................................
II F2
2-8
Monitoring of first earth fault...................................................................................
II F2
2-8
Insulation monitor unit “ISOMETER“ type IRDH 265 – 3 (Bender-Relay).......
II F2
2-8
Insulated DC drive, 12 – pulse parallel configuration .....................................
II F2
2-8
Insulated DC drive, 12 – pulse serial /sequential configuration ......................
II F2
2-9
Monitoring of second earth fault .............................................................................
II F2
2-9
2.5 Advanced current measurement ...........................................................................
II F2
2-10
2.6 Control, Trip, Emergency operation ......................................................................
II F2
2-11
Drive logic DCS 600 .............................................................................................
II F2
2-11
Tripping behaviour................................................................................................
II F2
2-12
Software 15.606/15.204...............................................................................
II F2
2-12
Software 15.607/15.206 or higher...............................................................
II F2
2-12
Hardware connections..........................................................................................
II F2
2-13
12 – pulse parallel configuration ..................................................................
II F2
2-13
12 – pulse serial/sequential configuration ....................................................
II F2
2-14
12 – pulse configuration with only one main contactor.................................
II F2
2-15
Chapter 3 – Twelve–Pulse Parallel Configurations with DCS 600
3.1 Twelve–pulse parallel hardware configurations.......................................................
II F2
3-1
12 – pulse parallel configuration with master / slave 12 – pulse communic. link.....
II F2
3-1
Two drive systems in 12 – pulse parallel configuration with
master / follower link used for tandem mills............................................................
II F2
3-2
3.2 Twelve–pulse parallel Software configurations .......................................................
II F2
3-3
12 – pulse communication via SDCS–CON-2 channel V260 (12 – pulse link) ........
II F2
3-3
Dataset for 12 – pulse parallel mode ......................................................................
II F2
3-3
To Next Page
Loading...
Need help?
General
