ABB DressPack User Manual

2.3 Fitting the process turning disc
Location of the process turning disc
The process turning disc is located in the front of the wrist housing as shown in
the figure.
xx1500003047
Required tools and equipment
NoteArticle numberEquipment, etc.
Content is defined in section Standard
toolkit on page 233.
-Standard toolkit
Lifting capacity: 1,000 kg-Roundsling 1 m
Fitting the process turning disc
Screw joints for fitting the process turning disc
Tightening
torque
Number of
washers
Number of
screws
Screw dimen-
sion
Variant
120 Nm22 pcs22 pcsM12x403HAC051003-005
Continues on next page
Product manual - DressPack/SpotPack IRB 8700 59
3HAC055802-001 Revision: B
© Copyright 2015-2017 ABB. All rights reserved.
2 Installation
2.3 Fitting the process turning disc

ABB DressPack Specifications

General

Brand	ABB
Model	DressPack
Category	Industrial Equipment
Language	English