ABB M101 - Hardware Types and Technical Data

INTRODUCTION HARDWARE TYPES AND TECHNICAL DATA
1TGC908004M0201 7
2.1. Hardware Types and Technical Data
The configuration of MNS Digital Gateway depends on the selected communication protocol
to the DCS. For the Modbus communication to DCS the hardware shown in the table below is
applicable
Fie
ldbus Protocol
Modbus
Fieldbus Hardware
Interface
RS 485 & Ethernet
TCP/IP
IEEE 802.3
RS 422 & Ethernet TCP/IP
IEEE 802.3
RS 232 & Ethernet
TCP/IP
IEEE 802.3
MNS Digital Gate-
way ID
1TGE120021R0810
Picture
Table 1 MNS Digital Gateway Modbus Hardware
For communication to M10X, MNS Digital Gateway is connected via RS485 with Modbus RTU
protocol. As one segment of Modbus RTU is only able to support 32 devices, MNS Digital
Gateway for M10x is supplied with four Modbus RTU port to support a maximum of 128 num-
ber of devices.
ELECTRICAL DATA
Power Supply
24
V DC (
19
–
31
V DC)
Power Consumption
Typical
800
mA, maximum
1000
mA
MECHANICAL DATA
Weight
2.5
kg
Dimensions H x W x D
140
x
160
x
165
mm
ENVIRONMENTAL DATA
Storage Temperature
-
20
o
C to + 70
o
C
Operating Temperature
0
o
C to 55
o
C
Degree of Protection
IP51
MTBF (Mean Time Between Failures)
46 years @ 40
o
C
Table 2 MNS Digital Gateway Technical Data