SWITCHGEAR BUS NETWORK COMMUNICATION INTERFACE CONNECTION
16 1TGC908004M0201
Parameterization of communication setting in M10x can be done either via the MD panel on
the MNS module front or with a Laptop with ‘MCUsetup’ software tool installed. For further
detail on changing the setting, refer to “
M10x User Guide”
document.
In addition to the terminating resistor, it is also required to install a shielding clamp for the
RS485 communication to reduce EMC disturbances. The following figure shows a sample of
the clamp that can be used for shielding purpose.
Figure 10 Shielding Clamp for RS485
To Next Page
Loading...
