ABB M101 - Switching Commands; Table 28 Switching Commands Sent from DCS to MNS Digital Gateway

DATA MAPPING DEFAULT DATA MAP
1TGC908004M0201 55
9.2.6. Switching Commands
The following table details the commands that are required from the Master (DCS / PLC) to
be sent to the M10x-M in order to control the motor or feeder module.
Operation
Type
Description Modbus
Command
Remarks
Control Access
Remote control 0x2100 M10x-M is controlled
via DCS.
Bus-Local control 0x2104 DCS allows control via
local HMI.
Stop Stop, Open 0x0201 Stops the M10x-M,
Opens contactor K1 for
Contactor Feeder ap-
plication
Start
Start CW
Close (CF)
Open (Act)
Start
Start Clockwise
Close for Contactor Feeder applica-
tion
Open for Actuator application
0x0202 Starts the M10x-M.
Close contactor K1
Start CCW
Close (Close)
Start Counterclockwise
Close for Actuator Application
0x0203 Start the M10x-M
Counterclockwise.
Close contactor K2.
Reset Reset 0x1100 Reset of all trips
Table 28 Switching Commands sent from DCS to MNS Digital Gateway