ABB M101 - Settings - Modbus TCP Communication

SETTINGS – MODBUS TCP COMMUNICATION CONFIGURATIONS
36 1TGC908004M0201
f
Figure 30 Parameter Window for MODBUS RTU parameters in MNavigate
7.5. Settings – Modbus TCP Communication
Parameter Default Value Range
Remarks
IP Address LAN 1 (LAN1) 192.168.100.100
Settings according to network ad-
ministrator
Subnet Mask LAN1 255.255.255.0
Settings according to network ad-
ministrator
Broadcast Address
LAN1
192.168.100.255 Calculated automatically
Default Gateway LAN1 0.0.0.0
Settings according to network ad-
ministrator
Slave address 247 1…247 RTU Slave Address
Port 502 502 TCP Port Number
PLC Time Out enable No Yes / No Activates PLC time out
PLC Failsafe Time Out 10 1….100 Delay until Failsafe is activated
DCS Command Format MNSiS
MNSiS,
INSUM 1,
INSUM 2
Only for MNS Digital Upgrade solu-
tion for INSUM 1 and 2:
Support of DCS command format
in INSUM 1, INSUM 2 and MNS i S
Table 13 MNS Digital Gateway Default Parameters – Modbus RTU configuration