ABB ProcessMaster User Manual

Parameter overview
64 - EN FEX300, FEX500 CI/FEX300/FEX500-EN
FF
Show FF Address
AI1-Q Flowrate
INT1-Q Flowrate
AI2-Internal Tot Fwd
AI3-Internal Tot Rev
AI4-Diagnostics
AO-Density Adjust
DI-Alarm Info
DO-Cyclic Control
Diagnostics
8
Diagnosis Control Empty Pipe Detector
Empty Pipe Detector
Adjust EP
Manual Adjust EP F.
Threshold
Detector EP Value
Sensor Measurements
Sensor Measurements
One shot Sensor Mea
Coil Current
Coil Resistor
Coil Voltage
Coil R. Max Alarm
Coil R. Min Alarm
Signal-Cable length
Sensor Temp Value
Adj. Sensor T. Value
Sensor T. Min Alarm
Sensor T. Max Alarm
Gas Bubble Detector
Gas Bubble Detector
Adjust Gas Bubble
Threshold Gas Bubble
Gas Bubble Value
Coating Detector
Coating Detector
One shot Coating
Coating Value QE1
Coating Value QE2
Coating QE Min Alarm
Coating QE Max Alarm
Cond. Detection
Cond. Detection
One shot Cond.
Cond. Value
Adj. Cond. Value
Cond. Min Alarm
Cond. Max Alarm
Elec. Imp. E1-GND
Elec. Imp. E2-GND
Elec. Imp Min Alarm
Elec. Imp Max Alarm
italics = Parameter can only be changed at the "advanced" password level.

ABB ProcessMaster Specifications

General

Type	Electromagnetic Flowmeter
Liner Material	PTFE, PFA, Polyurethane, Rubber
Electrode Material	Stainless steel, Hastelloy, Tantalum, Titanium, Platinum
Process Connection	Flange, Wafer
Fluid Temperature	-40 to 180 °C (-40 to 356 °F) Depending on liner
Output	4-20 mA, HART, PROFIBUS PA, FOUNDATION Fieldbus
Power Supply	100 to 230 V AC, 24 V AC/DC
Protection Class	IP67
Approvals	ATEX, IECEx, FM, CSA