ABB REC650 - Indication Combining Single Position Function Block INDCOMBSPQT

Table 314: INVALIDQT Output signals
Name Type Description
OUTPUT1 BOOLEAN Indication output 1
OUTPUT2 BOOLEAN Indication output 2
OUTPUT3 BOOLEAN Indication output 3
OUTPUT4 BOOLEAN Indication output 4
OUTPUT5 BOOLEAN Indication output 5
OUTPUT6 BOOLEAN Indication output 6
OUTPUT7 BOOLEAN Indication output 7
OUTPUT8 BOOLEAN Indication output 8
OUTPUT9 BOOLEAN Indication output 9
OUTPUT10 BOOLEAN Indication output 10
OUTPUT11 BOOLEAN Indication output 11
OUTPUT12 BOOLEAN Indication output 12
OUTPUT13 BOOLEAN Indication output 13
OUTPUT14 BOOLEAN Indication output 14
OUTPUT15 BOOLEAN Indication output 15
OUTPUT16 BOOLEAN Indication output 16
Settings
The function does not have any parameters available in Local HMI or Protection and
Control IED Manager (PCM600).
11.3.2.11 Indication combining single position function block INDCOMBSPQT
Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Single indication signal combining
function block
INDCOMBSPQT - -
Functionality
Single position input is copied to value part of SP_OUT output. TIME input is copied
to time part of SP_OUT output. State input bits are copied to the corresponding state
part of SP_OUT output. If the state or value on the SP_OUT output changes, the Event
bit in the state part is toggled.
Section 11 1MRK 511 287-UEN A
Logic
370
Technical manual