Assembly Instructions
Assembly
1HSB435410-2 enrev1 11
4.2 Frame assembly
The frame is supplied in welded halves with six cross stays and nuts, bolts and
washers.
Bolt the halves together as shown in Figure 4-3. Fit the cross stays according to
the numbering 1-4, using the supplied nuts, bolts and washers.
N.B. Make sure the stays are fitted as set out in Figure 4-3 and to the intended
operating mechanism.
Tighten the bolted joints to a torque of 430 Nm.
Figure 4-3. Frame assembly.
Item
1 Frame halves 2 pcs.
2 Stays 6 pcs.
3 Bolts M20x60
Nuts M20
Washers 21x37x3
8 pcs.
8 pcs.
16 pcs.
4
3
2
1
1
2
3
TIGHTENING TORQUE
430 Nm
B10005
To Next Page
Loading...
