ABB UMC100.3 - Display Parameters; Maintenance and Service Parameters;Actions

 Display
 Language
 Tag name
 Tag name L2
 Backlight
 LCD Panel T unit
 User display 1
 User display 2
 User display 3
 User display 4
 User display 5
 User display 4 text
 User display 5 text
 Password protection
 Enable Auto Save
 En Auto Save React
 Panel HW + SW Version
 Password protection
 Password enabled
 Change password
 Maintenance / service
 Maintenance counters
 Service tasks
 Diagnosis
 Parameter transfer
 Changed parameters
 UMC 100 SW version
 Maintenance counters
 Motor operation hours
 Mot. stand still hrs
 Number of starts
 Number of trips
 Remaining starts
 Service Tasks
 Set operation hours
 Reset oper. hours
 Set stand still hrs
 Reset stand still hrs
 Reset num. od starts
 Reset num. of trips
 Reset parameters
 Reset energy
 Diagnosis
 Error history
 Present warnings
 Parameter transfer
 Upload to LCD panel
 Download to UMC
 Upload to LCD panel
 Only parameter
 Only application
 Par and application
 Download to UMC
 Only parameter
 Only application
 Par and application
Maintenance and Service Parameters/Actions
Within this submenu all maintenance and service related parameters / actions can be configured. The figure below shows
the organisation of the different parameter masks in the menu tree. Menu point 6.3.1 shows the list of errors and their occurrence
in seconds since the start-up of the UMC. After a power cycle the history buffer is cleared. Use the up/down keys to scroll within
the list. Menu point 6.3.2 shows present warnings. The "i" in the icon bar on the top level masks indicates the presence of warnings.
Use the up/down keys to scroll within the list. Menu point 6.5 lists all changed parameters. This is useful if you want to verify the
parameterization was carried out correctly or when calling a technical specialist who wants to know what has been configured.
Menu point 6.4 allows to transfer the parameters and/or the application to the LCD panel and back.
Display Parameters
Within this submenu all LCD display related parameters can
be configured. The figure shows the organization of the
different parameter masks in the menu tree.
The parameters are described in details in the section
"Parameters and Data Structures on a Fieldbus->Parameter
Organization->Display Parameters".
107
THE LCD CONTROL PANEL UMC100-PAN