ABB UMC100.3 - Adjust Cyclically Transmitted Monitoring Words

Adjust cyclically transmitted Monitoring Words
By default the cyclically transmitted monitoring words are predefind as in the previous versions of UMC100.3
(e.g. first word contains the motor current in % of Ie). But depending on the connected expansion modules or special
application needs it is possible to adjust the transmitted analog monitoring words with the help of the parameters listed below.
Relevant parameters:
• Param To PV 1/2/3/4/5
Special considerations for backwards compatibility on DeviceNet and PROFINET
The UMC100.3 is fully backwards compatible with UMC100-FBP.
To replace a UMC100-FBP with UMC100.3 without changing the device description files in a bus master it is necessary
to adjust the parameter "Retrofit" to "UMC100-FBP" using the LCD operator panel.
Relevant parameters:
• Retrofit
98
UMC100.3 UNIVERSAL MOTOR CONTROLLER TECHNICAL DESCRIPTION