ABB UMC100.3 - Monitoring Data for Overload Relay; Command Data Overload Relay

—
Monitoring Data for Overload Relay
Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0

 Summary
Warning
Summary
Fault
- - Overload
warning
- - -
       - -
 
Remaining data see section Parameters and Data Structures on a Fieldbus
 
 
 
 






The table above represents the data allocation as realised with the built-in standard applications. It may differ for
customer-specific applications!
—
Command Data Overload Relay
Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0

 - Fault Reset - Prepare
Emergency
Start
- - - -
 


- - 


- - - -

 Remaining data see section Parameters and Data Structures on a Fieldbus

 
 
1) Controlled by UMC100 if configured as fault output.
The table above represents the data allocation as realised with the built-in standard applications. It may differ for
customer-specific applications!
73
CONFIGURING THE MOTOR MANAGEMENT FUNCTIONS