ABB UMC100.3 - Timing Diagram for Direct Starter; Monitoring Data for Direct Starter

Timing Diagram for Direct Starter
—
Monitoring Data for Direct Starter
Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0

 Summary
Warning
Summary
Fault
Local Control - Overload
warning
Run Forward Off -
       - -
 
Remaining data see section Parameters and Data Structures on a Fieldbus
 
 
 
 






The table above represents the data allocation as realised with the built-in standard applications. It may differ for
customer-specific applications!
RUN FORWARD
OFF
RUN FORWARD
OFF
FAULT RESET
FAULT
WARNING
FAULT
DO0
2CDC 342 023 F0209
Check-back
Commands
(received
telegram)
UMC outputs
Monitoring signals
(telegram)
LED
DI0
(aux. contact)
Motor current /
aux. contact
Run Run
Diagnosis
(telegram)
UMC internal
Cooling time running
Overload
Fault (red)
Over-
load
Fault
reset Run
End of
cooling time
Cooling time
75
CONFIGURING THE MOTOR MANAGEMENT FUNCTIONS