New features in comparison to preceeding versions
New protection functions
• The new analog input module AI111.0 adds three analog inputs to the UMC100. Up to two AI111 .0 can be connected to the
UMC100.3 at the same time. See section 4 -> RTD based Temperature Supervision and Analog Inputs for details.
• Single phase / three phase operation modes
New motor management functions
• Control functions for load feeder and softstarter
• Standstill and operating hours supervision
Fieldbus communication
• The new communication adapters use no M12 connectors and cables anymore.
• Standard fieldbus cables and fieldbus connectors can be used.
Supply voltage
• There is an additional UMC100.3 version for 110 V AC/DC to 240V AC/DC supply voltage.
•
Other new functions
• The LCD panel offers a USB interface for configuration via laptop
• The LCD panel supports Polish as an additional language
• Availability to display all three phase currents
New features in UMC100.3
Additional functions in newer releases; Firmware version can be identified with operator panel, maintenance menu
V3.05 - New Ethernet settings via operator panel
- More Modbus RTU settings
the motor
The UMC100.3 is fully backwards compatible with the previous version and replaces it. To use the new features via
fieldbus new fieldbus device description files have to be used. Therefore updated GSD and EDS files are available
on the ABB web site. See section A1 for details.
need not be changed.
The UMC100.3 size is very similar to the previsous UMC100-FBP.0 version. Some connector positions have
changed. Please see technical data for details.
To Next Page
Loading...
