ABB UMC100.3 - Activating Inching Mode

UMC with
DNP31
UMC with
DNP31
AC500
with
DeviceNet
Master
Using the UMC100.3 in a DeviceNet Network
DeviceNet is based on the Controller Area Network (CAN) technology and mostly used in the Americas.
To integrate the UMC100 into a DeviceNet network use the DNP31 communication interface.
The figure below shows the sketch of a DeviceNet line with DNP31 and UMC100s.
More details are available in the technical manual of the DNP31.
—
DeviceNET Line with UMC100.3 and DNP31. Use standard DeviceNet cable for wiring
30
UMC100.3 UNIVERSAL MOTOR CONTROLLER TECHNICAL DESCRIPTION