—
Command Data for Direct Starter
Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
- Fault Reset Auto Mode Prepare
Emergency
Start
- Run
Forward
Off -
-
- - - -
Remaining data see section Parameters and Data Structures on a Fieldbus
1)
Controlled by the UMC100 if configured as fault output
The table above represents the data allocation as realised with the built-in standard applications. It may differ for
customer-specific applications!
76
To Next Page
Loading...
