Chapter 6 - Operation
UNITROL 1020 User Manual 3BHS335648 E82 117
6.4.5.1 Help Menu
Software and AVR Information
SW Update
About CMT1000
AVR S/N: Unit’s serial number
Control: DSP software version
MCU: Panel software version
SW Revision: CMT1000 version
Configuration: ABB or Custom
Click on the window to close it.
Note: the serial number of the AVR is
shown in the window of and it should
be provided when an optional software
is requested from ABB.
Figure 6-13 About CMT Window
6.4.5.2 File Menu
*. ini (see warning message below)
saves the parameters to the PC hard disk
saves the parameters to the device’s EEPROM
user defined application
enables SW optional features (password required)
closes the application
saves the parameters to an XML File
Open Parameter File
A set of parameters values, previously stored in a so-called Configuration INI file, can be
downloaded to the AVR by using the option Open Parameter File from the CMT1000
menu. In order to download parameters to the AVR, make sure that the CMT1000 has
Control Access before trying to use the Open Parameter File option. The Configuration INI
file can also be opened when OFFLINE, in order to verify the values of the parameters,
prior to downloading them to the AVR.
The Configuration INI file should be compatible and previously created with CMT1000
release 5.xxx, otherwise a warning message may show up. Additionally, a message
indicating writing failure can appear after continuing the download of the incompatible
configuration INI file, when it contains at least one parameter value out of the permitted
range of selection.
The download of an incompatible configuration INI file is not recommended and it is up to
the user to verify if all parameters are set correctly before going into Operation with the
AVR.
To Next Page
Loading...
