now enabled.
4. After the oval button is lit click
the button “Save to EEPROM“,
to make the change permanent
even after restarting the device.
5. In the CMT1000 main window,
click in File and then, in "Write
Parameters to EEPROM".
6. Restart the device.
7. After the unit is powered up,
check if the SW-Option remains
enabled. If not, repeat the
procedure starting by Step 1.
Figure 6-16.The SW Options window allows
the user to enable optional software in the
AVR.
Figure 6-17 Upper: LED is bright when the
optional SW is enabled in the AVR. Lower: A
wrong password does not enable the SW.
To Next Page
Loading...
