ABB UNITROL 1020 - Page 127

 Chapter 6 - Operation
UNITROL 1020 User Manual 3BHS335648 E82 119
Customer Setup
Option for user-defined application
and OEM customers (password
protected).
SW-Options
It allows the user to enable (unblock) optional software in the AVR. A password code is
required for each specific function (SW-option) and it shall be ordered with ABB.
The following steps should be
followed in order to enable optional
software in the UN1020:
1. Make sure the CMT1000 has
Control Access (Figure 6-15).
2. Type the password provided by
ABB (case sensitive) in the
white box located beside the
SW-option intended to enable
(Figure 6-16). Click the Enter
key on the keyboard in order to
validate the password.
A couple of seconds after
clicking Enter, the oval button at
the right side of the white box
should not be shaded anymore.
Check the password spelling if
this is not the case.
The behavior rules for the SW
activation buttons are shown in
Figure 6-17.
3. Once the oval button becomes
clear, click the button once.
After a few seconds the LED on
the button should be bright,
indicating the optional SW is
Figure 6-15 CMT1000 must have Control Access before
enabling optional SW.