ABL eMS home - Functions of the Reset Button; Licences

| Appendix – Functions of the reset button
50
Network LED
Colour Status Description
– Off No connection
Green Illuminated Link
Green Flashing Activity
Serial bus LED
Colour Status Description
– Off No connection
Green Flashing rapidly Connection active
Green Flashing slowly Scanning active
Red Illuminated Error - overload at 9V output
Orange Flashing Error - remote station not responding
Functions of the reset button
Restart eMShome
► Use a pointed object to press and hold the reset button1 for just over 6seconds.
The eMShome will then restart.
Reset the password for the web interface
► Press the reset button1 as follows:
y 1×long (between 3 and 5seconds),
y then within 1 s: 1×short (0.5second)
If the command was recognised correctly, the Status LED2
flashes orange twice. The password for the web interface is re-
set to the factory default (see Rating plate on page7).
Reset network settings
► Press the reset button1 as follows:
y 1×short (0.5second),
y then within 1 s: 1×long (between 3 and 5seconds).
Resetting the network settings activates DHCP, among other things. If the command was recognised correctly, the
Status LED2 flashes orange twice.
Licences
This product also contains open source software that was developed by third parties. This includes the GPL and LGPL
licenses.
The licence texts containing the associated information can be found on the eMS home web interface in the footer
under Licenses.
1
2