59
e) BACnet and Ethernet Module Parameter
When the second communication protocol is set to BACnet, there is parameters
display related to BACnet, while these pages only show as modules successfully
connecting with meter. If meter does not detect any module, there will show
LOADING page. To set these parameters, rst, select, then modify and save. On
the one side, if there is no extra BACnet module, setting will be meaningless
and not saved after shutting down. On the other side, setting is valid and will be
saved into BACnet module when there is a BACnet module attached.
When the second communication is set to MESH,where is parameter display
related to MESH module.
When second communication protocol is other protocol, there is parameters
display related to Ethernet. The condition is same as above.
Key functions for nding the Ethernet module parameter:
Press H to return to parameter selection mode.
The screen will roll to the next page each time P is pressed and will return to the
rst page when P is pressed at the last page.
The screen will roll to the last page each time E is pressed and will return to the
last page when E is pressed at the rst page.
Press V/A to modify the selected parameter.
Key functions for modifying the parameter:
Press H to move the ashing cursor to the next position.
Press P to increase the number by 1, while the number was 9(Ethernet), or
7(BACnet IP), or 3(BACnet MS/TP), the number will return to 0 after press P.
Press E to decrease the number by 1, while the number was 0, the number will
return to 9(Ethernet), or 7(BACnet IP), or 3(BACnet MS/TP) after press E.
To Next Page
Loading...
Need help?
General
