Acer A100 - Battery Installation

3-18 Machine Maintenance Procedures
NOTE:
NOTE:
Make sure antenna and GPS cables (E) are clear of battery before removal
Figure 3-24. GPS and Antenna Cables
4. Remove battery from shield case.
Battery Installation 0
1. Install battery (A) on shielding case. (Figure 3-20)
NOTE:
NOTE:
Place cables (E) between battery and 3G module. (Figure 3-24)
2. Install and secure screws (D) to shielding case. (Figure 3-22 and Figure 3-23)
3. Connect battery cable (B) to mainboard connector (C). (Figure 3-21)
4. Install lower case.
ID Size Quantity Screw Type
A M2.0x4.0 Ni 4
E