Machine Maintenance Procedures 3-21
3. Carefully pry up the top center edge of the upper case (D) to remove (Figure 3-18).
4. Disconnect the touchpad FPC (B) from the touchpad module connector (E)
(Figure 3-19).
Figure 3-19. Touchpad FPC Removal
Upper Case Installation 0
1. Secure three (3) screws (A). Refer to Figure 3-17.
2. Connect the touchpad FPC (B) to the touchpad module connector (E) (Figure 3-19).
3. Install the upper case on the lower case.
4. Connect the touchpad FPC (B) to the mainboard connector (C) (Figure 3-18).
5. Install the base cover.
ID Size Quantity Screw Type
A M2.0*4.0 3
To Next Page
Loading...
