Acroprint ES700 - Set Password Protection; Enter Password to Change Settings; Cancel Password Protection

ES700 User’s Manual 27
Change the Month
1. In this example, press CHANGE until the month is "11" (November). Refer to DST on page 23.
2. Press SET.
3. The flashing changes from "Month" to "Date".
Change the Date
1. In this example, press CHANGE until the date is "02". Refer to DST on page 23.
2. Press SET.
3. The "Ending Date" of the display changes from flashing to steady and the S mark is
displayed under "SU".
Set Password
Once the password is set, you must enter it before changing any settings. Refer to “Enter Password”
on page 29.
Example: Set the Password to "1234".
1. Press SELECT until the T is above the "PASSWORD" mark.
You may choose any 4-digit number from 0001 to 9998.
Numbers "0000" and "9999" are not valid passwords.
All settings must be reset if you forget the password. Refer to “Reset Factory Default
Settings” on page 30.
SELECT CHANGE SET
DST
END
SU
SELECT CHANGE SET
DST
END