EasyManuals Logo

ACS Tech80 SB1391 User Manual

ACS Tech80 SB1391
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
RECENT CHANGES TO THIS GUIDE I
SB1391 Hardware and Setup Guide - Document revision no. 1.14
RECENT CHANGES TO THIS GUIDE
Ver. Date Section Change ECR
1-11 Sept./00 4.5.1 Description of CAN indicator LED states improved.
1-11 Sept./00 4.4.5 and
7.5.1.1
Warning added: Controller does not provide hardware
facilities for hardware Emergency Stop or Safety Interlock.
1-11 Sept./00 4.4.5 and
7.5.1.1
Warning added: E-STOP input is only for indicating that an
emergency situation exists. It cannot be used as the Emergency
Stop for the entire system.
1-11 Sept./00 4.4.3,
4.4.4,
and 7.3
Warning added: Encoder support does not include facilities for
over-speed protection.
1-12 Oct./00 4.3.3.1 Added replacement instructions for regeneration resistor fuse.
1-12 Oct./00 4.4.6 Corrected TABLE 4-22, connection pins for the HSSI/PEG
connector (J5).
296
1-13 Oct./00 7.5.4 Updated description of ACSPL analog output parameters.
1-13 Dec./00 4.3.1.1 Warning added for drive supply: If using secondary circuit to
supply the SB1391, supply must be suitably European
Approved.
1-13 Dec./00 4.3.1.1.3 Warning added for control supply: If using secondary circuit
or DC direct to supply the SB1391, supply must be suitably
European Approved.
1-13 Dec./00 4.4.5 Warning added for I/O supply: If using secondary circuit or
DC direct to supply the SB1391, supply must be suitably
European Approved.
1-13 Dec./00 4.3.2 Warning added for motor connection: Wiring and output must
be in accordance with the relevant safety requirements of the
EN 60204-1 standard (latest version).
1-13 Dec./00 4 Warning added for mounting (installation): The SB1391 must
be enclosed or incorporated into an end-product in accordance
with the EN 60204-1 standard (latest version) for electrical
shock, environmental (IP), and earthing requirements.
1-13 Jan./01 4.3.3.1 Description of internal fuses and external regeneration resistor
fuse added.
1-13 Jan./01 4.3.1.2 Control supply must be minimum 1.5A.
1-13 Jan./01 4.3.1.1.3 Description of phase-loss detection for three-phase drive
connection added.
1-13 Jan./01 Cover Copyright, area code, and disclaimer updated.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ACS Tech80 SB1391 and is the answer not in the manual?

ACS Tech80 SB1391 Specifications

General IconGeneral
BrandACS Tech80
ModelSB1391
CategoryController
LanguageEnglish