INSTALLATION & MAINTENANCE MANUAL • X-MIND DC • (06) • 10/2018 • NXDCEN020F
Pag. 7 of 51
PRELIMINARY INFORMATION
1.1. PRELIMINARY INFORMATION
Before beginning to use the radiographic system, it is mandatory to carefully read and follow the instructions contained
herein, so as to obtain the best possible performance and to assure the safety of the patient, operator, device and
environment.
Always pay close attention to the
CAUTION
WARNING
PLEASE NOTE
messages when operating the system.
LEGEND
CAUTION
The word CAUTION identifies those occurrences which might compromise the operator’s personal safety or cause injuries
to people.
WARNING
The word WARNING identifies those occurrences which might compromise the radiographic system’s performance.
PLEASE NOTE
PLEASE NOTE serve to give special indications so as to facilitate maintenance or make important information clearer.
1.2. INFORMATION FOR THE INSTALLER
CAUTION
The installer is responsible for the installation, with regards to the system safety and operation.
For safe and reliable installation of the radiographic system it is advisable to:
check that the voltage mentioned in the rating plate matches the line voltage;
, install the radiographic system according to the procedures described in this manual;
, provide the user with any information regarding the use of the radiographic system according to what stated
in the manual;
, certify the work done by filling-in the “Installation Check-list” to be returned to de Götzen S.r.l. – ACTEON
Group.
1.3 WARRANTY CONDITIONS
Inappropriate use or any arbitrary tampering with the equipment exempt de Götzen S.r.l. – ACTEON Group, as
manufacturer of the radiographic system, from any service under warranty.
The warranty is valid only if the following precautions are taken:
, any repairs, modifications, adjustments, recalibrations must be performed only by de Götzen S.r.l. – ACTEON
Group;
, the installation must be made by professionally qualified technicians according to the regulations in force;
, the system must be installed and used in compliance with the instructions given in this manual and for the
purposes and applications for which it was designed;
To Next Page
Loading...
