22
4.3.1. Intel WiDi (Gen 4)
You can activate Ultra-Low Delay on a device running Intel WiDi (4.x.x.x). Follow the steps
below to switch to ultra-low delay mode:
1. Launch the Intel WiDi application, connect to the receiver you are using, and then click
the Settings button.
2. On the "Settings" screen, select Current Display Settings.
3. Select Prioritize Speed in the "Quality vs. Speed" section and click the Apply Settings
button.
4.4. USB over Network
The Receiver’s USB over Network (UoIP) feature allows the use of USB HID peripheral
devices, either from the source device or from the USB device side. To connect a USB
keyboard, mouse, or trackpad:
1. Log into the receiver’s local web management console, and set the UoIP or UIBC feature
to Enable. Refer to Section 5.3.11. Setting up USB Local Access for details.
2. Plug the device into the Receiver’s USB port and wait for the device to be detected. This
may take 10-15 seconds.
3. Use the USB keyboard, mouse, or trackpad to control the source device.
Note: UoIP is compatible with Intel WiDi only.
To Next Page
Loading...
