24
4. The receiver reboots, and new settings take effect after the reboot.
Setting up P2P Network Parameters for detail.
Follow the procedure below to log into the local management server when AGO is enabled.
1. Connect your device to ScreenBeam Pro.
2. Access the URL address (http://192.168.16.1) with a web browser on your device.
3. The web server login interface appears. Type the username and password in the
Username and Password boxes and click the Login button.
Note:
By default, the Username is “Administrator” and Password is “WiDi”. You can modify
the username and password in the local management web page. Refer to Section 5.3.2.
Setting up Login Username and Password for the Local Management for detail.
The username and password are case sensitive.
When Autonomous GO is enabled, the SSID of the receiver is reserved.
5.1.2. When Autonomous GO is Disabled
When Autonomous GO is disabled, you must connect your device to the receiver’s SSID,
and then access the URL address (it is "http://192.168.51.1" by default) with a web browser.
Note: You can set the receiver’s network information to be displayed on the Ready to
connect screen. Refer to Section 5.3.17. Setting up Network Information Display on TV Screen
for detail.
There are two situations: when the SSID broadcast is enabled and when it is disabled.
5.1.2.1. When SSID Broadcast is Enabled
Follow the procedure below to log into the local management web server:
1. Connect to the receiver’s SSID from a wireless-enabled laptop (or other devices with Wi-
Fi access ability and a web browser). You can find the SSID in the lower part of the Ready
to connect screen.
To Next Page
Loading...
