38
1. Go to the Features tab page by clicking the Features tab.
2. Configure the USB Local Access feature according to practical requirements.
There are three options: Disable, Only allow firmware update, and Enable.
Disable: Select "Disable" to disable the USB port on the receiver.
Only allow firmware update: Select "Only allow firmware update" to allow users to
upgrade the receiver's firmware through the USB port.
Enable: Select "Enable" to allow full functions of the USB port. In this case, users not
only can upgrade the receiver, but also can control the source device by connecting a
keyboard/mouse to the receiver via the USB port (with the User Input Back Channel
(UIBC) or USB over IP (UoIP) function enabled).
UIBC: The connected keyboard/mouse does not support combo keys or mouse
right-click.
UoIP: The connected keyboard/mouse supports full functions.
Note: UoIP is compatible with Intel WiDi only.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
5.3.12. Adjusting TV Screen Size
If edges of the device screen cannot be seen on the HDTV or you can see black edges, you
can adjust the TV screen size (overscan).
Follow the procedure below to adjust the size of your TV screen:
1. Go to the Features tab page by clicking the Features tab.
To Next Page
Loading...
