46
Analyzer to help you identify a clean channel.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
5.3.20. Setting up Group Owner Intent
When the AGO function is disabled, the Group Owner Intent function is available. The
Group Owner Intent function is used to determine which device (receiver or connecting
device) will be the group owner.
Follow the procedure below to set up the receiver’s group owner intent:
5. Go to the Features tab page by clicking the Features tab.
6. Select a desired value from the Group Owner Intent drop-down box.
Note: The larger the value is, the more likely the receiver becomes the group owner of the
P2P connection.
7. Click the Apply button, and then click OK on the pop-up message box to confirm.
8. The receiver reboots, and new settings take effect after the reboot.
5.3.21. Setting up P2P Network Parameters
When AGO is enabled, you can define network parameters for peer to peer connection,
To Next Page
Loading...
