47
including P2P Wireless Network Name (SSID), Password, IP address, subnet mask, DHCP
IP address range.
You should configure these parameters when you use the Managed Meeting function. When
source devices connect to the receiver, the receiver will assign IP addresses to these devices.
And these IP addresses are defined by the parameters discussed in this section.
Follow the procedure below to set up the receiver’s P2P network parameters:
1. Go to the Network Settings tab page by clicking the Network Settings tab.
2. Go to the Wireless Interface Settings section, and properly configure the network
parameters.
P2P Wireless Network Name (SSID) and P2P Wireless Network Password:
Reserved.
P2P IP Address: It is the IP address of the receiver in a peer to peer connection. This
IP address is displayed in the lower part of the Ready to connect screen. It is used to
access the local management server when AGO is enabled.
Note: The P2P IP Address must not in the range defined by P2P DHCP IP Start and
P2P DHCP IP End.
P2P Subnet Mask: It is the subnet mask for the network established in the peer to peer
connection.
P2P DHCP IP Start and P2P DHCP IP End: These two items define the range of IP
addresses assigned to the connected devices.
Note: These network parameters works when AGO is enabled.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
To Next Page
Loading...
