ActionTec ScreenBeam Pro SBWD100B - 5.2. Log Out

29
connection automatically”. Otherwise, go to the Networks page by clicking the
Network icon in the Notification Area and connect to the SSID.
9. Access the URL address ("http://192.168.51.1" in this example) with a web browser on
the laptop.
10. The web server login interface appears. Type the username and password in the
Username and Password boxes and click the Login button.
Note:
 By default, the Username is “Administrator” and Password is “WiDi”. You can modify
the username and password in the local management web page. Refer to Section 5.3.2.
Setting up Login Username and Password for the Local Management for detail.
 The username and password are case sensitive.
5.2. Log Out
1. Go to the Logout tab page by clicking the Logout tab.
2. Click the “Yes” button to log out.
3. You will log out from the local management web page immediately.
5.3. Configuring the Receiver
After you have logged into the web server, you can configure ScreenBeam Pro on the
webpage.
5.3.1. Renaming the Receiver
Follow the procedure below to rename the receiver:
1. Go to the Device Configuration tab page by clicking the Device Configuration tab.