ActionTec ScreenBeam Pro SBWD100B - Setting up PIN Pairing Method

32
For more information about Managed Meeting, refer to Section 4.1. Intel Pro WiDi and
Managed Meeting.
Follow the procedure below to set up the receiver’s Managed Meetings function:
1. Go to the Features tab page by clicking the Features tab.
2. To enable/disable Managed Meetings, set the Managed Meetings function to
Enable/Disable.
3. For better communication, you can define a port (Managed Meetings Port) for the
Managed Meetings, as shown below:
4. Click the Apply button, and then click OK on the pop-up message box to confirm.
5. The receiver reboots, and new settings take effect after the reboot.
5.3.5. Setting up PIN Pairing Method
For security purpose, you may be required to connect to ScreenBeam Pro with a PIN. You
can define the PIN pairing method in the local management page.
Follow the procedure below to set up the receiver’s PIN pairing methods:
1. Go to the Features tab page by clicking the Features tab.
2. Set the Force PIN Pairing on First Connection feature to On or Off.