23
Part V. Device Management for IT
Administrator
ScreenBeam Pro provides a local management web server to manage the device. With the
web server, IT administrators can setup, configure and upgrade the receiver.
5.1. Log into the Local Management Web Server
There are two methods to log into the local management web server.
5.1.1. When Autonomous GO is Enabled
When Autonomous GO is enabled, you can log into the local management web server
through "http://192.168.16.1". You must connect your device to the receiver, and then access
the URL address with a web browser.
Note: http://192.168.16.1 is the default URL address. You can modify this URL address in
the local management web page. Refer to Section 5.3.20. Setting up Group Owner Intent
When the AGO function is disabled, the Group Owner Intent function is available. The
Group Owner Intent function is used to determine which device (receiver or connecting
device) will be the group owner.
Follow the procedure below to set up the receiver’s group owner intent:
1. Go to the Features tab page by clicking the Features tab.
2. Select a desired value from the Group Owner Intent drop-down box.
Note: The larger the value is, the more likely the receiver becomes the group owner of the
P2P connection.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
To Next Page
Loading...
