43
The file size must not exceed 200 KB.
The best image size is 300*60 pixels.
4. Click the Apply button to upload the screensaver image to the receiver.
5. A confirmation message appears. Click OK to continue.
6. After a while, the screensaver image will be updated. You can check it on the connected
display when the screensaver is running.
5.3.17. Setting up Network Information Display on TV Screen
Follow the procedure below to set up the receiver’s network information display:
1. Go to the Network Settings tab page by clicking the Network Settings tab.
2. To enable/disable the Show network information on TV screen feature, go to the
Show network information on TV screen line, and set the feature to Enable or
Disable.
Note: By default, this feature is disabled. In this case, the network information is not displayed.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
After the network information display is enabled, network information is shown on the TV
screen.
To Next Page
Loading...
