33
Select "Off" to disable the PIN enforcement function. PIN entry or PBC is used when
connecting your device to the receiver for the first time.
Select "On" to enable the PIN enforcement function. In this case, you must enter a
PIN code on the device connecting to the receiver for the first time. When this
function is enabled, the system provides two PIN generation methods: Random
and Static.
Note: Some wireless display source devices do not support PIN entry and may not
be able to connect with the ScreenBeam receiver if this mode is enabled. Refer to
the device’s user manual for detail about enabling the PIN connection.
- Random: A PIN code is generated randomly by the system and displayed on
the connected HDTV/projector.
- Static: Users can define seven (7) digits, and then the system generates an
eight (8) digit PIN with that seven digits included.
Enter seven (7) digits in the Static box, click the "Apply" button, and the
system generates an eight (8) digit PIN and display it on the Static PIN field.
This PIN will not be displayed on the connected display.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
Note: If you have selected Static, do remember to check the PIN code in the Static PIN field
and write it down before clicking OK.
4. The receiver reboots, and new settings take effect after the reboot.
5.3.6. Managing HDMI/VGA Port Output
The HDMI/VGA Port Power management feature provides flexible options to control the
HDMI outputs. Follow the procedure below to manage the receiver’s HDMI/VGA port output:
To Next Page
Loading...
