48
4. The receiver reboots, and new settings take effect after the reboot.
5.3.22. Setting up Wireless Network Parameters
When AGO is disabled, you can define wireless network parameters for accessing the
receiver’s local management web server, including wireless network name (SSID) and
password, IP address, subnet mask, and DHCP IP address range.
Follow the procedure below to set up the receiver’s wireless network parameters:
1. Go to the Network Settings tab page by clicking the Network Settings tab.
2. Go to the Wireless Interface Settings section, and properly configure the network
parameters.
Wireless Network Name (SSID) and Wireless Network Password: The SSID and
password for accessing the receiver’s wireless network. The SSID is displayed when
AGO is disabled.
To Next Page
Loading...
