Moving from WipperSnapper to CircuitPython
Follow the steps on the Installing CircuitPython page() to install CircuitPython on your
board running WipperSnapper.
If you are unable to double-tap the RST button to enter the UF2 bootloader,
follow the "Factory Resetting a WipperSnapper Board" instructions below.
Uploading this sketch will overwrite WipperSnapper. If you want to re-install
WipperSnapper, follow the instructions at the top of this page.
Moving from WipperSnapper to Arduino
If you want to use your board with Arduino, you will use the Arduino IDE to loadany
sketch onto your board.
First, follow the page below to set up your Arduino IDE environment for use with your
board.
Setup Arduino IDE
Then, follow the page below to upload the "Arduino Blink" sketch to your board.
Upload Arduino Blink Sketch
Uploading this sketch will overwrite WipperSnapper. If you want to re-install
WipperSnapper, follow the instructions at the top of this page.
Factory Resetting a WipperSnapper Board
Sometimes, hardware gets into a state that requires it to be "restored" to the original
state it shipped in. If you'd like to get your board back to its original factory state,
follow the guide below.
Factory Reset
•
©Adafruit Industries Page 235 of 263
To Next Page
Loading...
