Simply connect the STEMMA QT cable from the STEMMA QT port on your board to th
e STEMMA QT port on the MCP9808.
Scan I2C Bus
First, ensure that you've correctly wired the AHT20 sensor to your Feather by
performing an I2C scan to detect the I2C device on the bus.
On the upper left-hand corner of the board page, click Start I2C Scan.
If you do not see this button, double-check that your Feather shows asOnline.
You should see a new pop-up showing a list of the I2C addresses detected by an I2C
scan. If wired correctly, the AHT20's default I2C address of 0x38 appear in the I2C
scan list.
•
©Adafruit Industries Page 245 of 263
To Next Page
Loading...
