Adafruit ESP32-S3

To Next Page

To Previous Page

I don't see the I2C sensor's address in the list

First, double-check the connection and/or wiring between the sensor and the

board.

Then, reset the board and let it re-connect to Adafruit IO WipperSnapper.

Create the Sensor Component

Now that you know the sensor can be detected by the Feather, it's time to configure

and create the sensor on Adafruit IO.

On the device page, add a new component to your Feather by clicking the +button or

the + New Componentbutton.

The Component Picker lists all the available components, sensors, and parts that can

be used with WipperSnapper.

Under theI2C Componentsheader, clickAHT20.

Adafruit ESP32-S3 - Page 246