Adafruit ESP32-S3 - Older Versions of Chrome; Reset the board

Once completed, you can continue to the next section.
Reset the board
Now that you've reprogrammed the board, you need to reset it to continue. Click the
reset button to launch the new firmware.
The TFT display will show "Adafruit Feather" in red, "ESP32-S3 TFT Demo" in yellow,
the battery stats (if a battery is plugged in) and the I2C device addresses for any I2C
devices present. As well, the NeoPixel will light up in a slow rainbow.
You've successfully returned your board to a factory reset state!
Older Versions of Chrome
We suggest updating to Chrome 89 or newer, as Web Serial is enabled by default.
If you must continue using an older version of Chrome, follow these steps to enable
Web Serial.
If you receive an error like the one shown
when you visit the WebSerial ESPTool site,
you're likely running an older version of
Chrome.
You must be using Chrome 78 or later to
use Web Serial.
As of chrome 89, Web Serial is already enabled, so this step is only necessary on
older browsers.
©Adafruit Industries Page 257 of 263