35
Please notice that the device will not be able to perform any exam while
connected via micro-USB port.
When the device is connected to a computer via USB port
the turning off is prevented. When you try to switch off the
2WIN a warning will advise you to remove USB cable.
9.6 Before operation
After charging the battery, be sure to set up date and time. Current date and time will be
used into measurement printout. As soon as the battery is assembled and charged, and time
has been set, the device is ready for operation.
The device has an automatic hardware self-test procedure that can be activated as an option
on the instrument MENU under FUNCTIONS/AUX/AUTO TEST. This procedure may be
executed any time to verify hardware integrity.
9.7 Data management disclaimer
When turned on the first time, 2WIN present a disclaimer document related to the
management of data telemetry of the instrument. The operator is asked to read the
document and accept the terms, if not 2WIN will work but some functionalities will be
disabled (Telemetry and Remote access). You can read the document at the end of this
manual (Appendix A) for all the details.
To Next Page
Loading...
Need help?
General
